A weaving defect can do more than spoil the appearance of a fabric roll. Depending on its position and severity, it may reduce usable width, interrupt cutting, create visible marks on a garment or lead to a buyer rejection. The useful response is not simply to mark a roll as defective; it is to identify the fault, record where it occurs and trace the likely cause.
Here are common defects found in woven fabric and the checks that help mills and buyers deal with them consistently.
Common defects in woven fabric
- Broken or missing ends: A warp yarn is broken or absent, often leaving a lengthwise line or gap in the fabric.
- Broken or missing picks: A weft yarn is missing or interrupted, creating a fault across the width.
- Holes: An opening may be linked to yarn breaks, loom problems, needle-like damage from handling or other mechanical causes.
- Weft bars: Horizontal bands or changes in appearance can be associated with variation in weft yarn, tension, loom operation or processing.
- Reed marks: Lengthwise lines may relate to reed dents, reed condition or the way warp ends pass through the reed.
- Oil and handling stains: Grease, oil, dirt or marks can be introduced during production, movement or storage.
- Slubs and thick places: Local thick places may come from yarn variation, contamination or spinning-related faults.
The visible appearance alone does not always prove the root cause. For example, a horizontal band may be caused by yarn variation or a process issue. Record what is seen first, then investigate the production history before assigning responsibility.
How to inspect and record a defect
Use the inspection machine, lighting and fabric speed specified in the agreed procedure. Record the roll number, defect type, position across the width, distance along the roll and severity. Photographs can help, but they should be linked to the roll and inspection record rather than stored without identification.
Check the fabric construction, width, GSM where required, roll length and label details alongside the visual inspection. A roll may have acceptable appearance but still fail a dimensional or construction requirement. Likewise, a small visible fault should be judged using the agreed acceptance rules, not an improvised decision made after the order is complete.

Trace the cause before choosing corrective action
When a defect repeats, check the process stage where it could have been introduced. For warp-related faults, review yarn quality, winding, warping, sizing, tension and loom condition. For weft-related faults, check the weft package, yarn continuity, insertion system and machine settings. For stains, review lubrication, cleaning, handling and storage.
Do not assume that every defect has one cause. A fault may involve more than one factor, and the investigation should be based on production records and physical evidence.
Controls that help reduce weaving defects
- Use yarn that meets the agreed count, strength and evenness requirements.
- Check package condition and yarn continuity before the next process.
- Maintain consistent warp preparation, sizing and tension.
- Keep looms, reeds and relevant machine parts in good condition.
- Train operators to stop and report recurring faults rather than allowing them to continue unnoticed.
- Review defect data by style, loom, shift and production lot to identify repeat patterns.
What buyers should agree before bulk production
Write down the fabric requirements clearly: fibre composition, yarn count, weave, ends and picks, finished width, GSM, colour, finish and required tests. Also agree the inspection method, defect classification, acceptance limit and how nonconforming rolls will be handled. Keep an approved sample and make sure the inspection team is working to the same specification revision.
For related checks, read our woven-fabric inspection guide and the article on snags, broken yarns and holes. To discuss a woven-fabric requirement with Hubei Jintian, send us the specification.



