A quotation may state 58 or 60 inches, but that figure does not tell the cutting room how much fabric can actually be used. Selvedges, damaged edges and other agreed exclusions can reduce the available area for marker placement. Buyers should therefore confirm the measurement basis before comparing prices or calculating consumption.
Three width figures buyers should keep separate
| Width term | What it describes | What the buyer should confirm |
|---|---|---|
| Total or edge-to-edge width | The measured span across the fabric. Depending on the method, selvedges may be included. | Whether the stated figure includes both selvedges and whether the fabric is relaxed or under tension. |
| Finished width | The width after the specified dyeing, finishing or other processing stage. | Which finishing stage applies, when the measurement is taken and whether the width is measured in a relaxed state. |
| Usable or cuttable width | The portion the cutting room can actually use after agreed exclusions. | Which selvedge, edge damage, defects or other zones must be excluded. Suppliers may use “usable” and “cuttable” differently, so define the terms in the order. |
A fabric can meet its total-width figure and still fail the buyer’s minimum cuttable-width requirement. Do not compare quotations until both suppliers are quoting on the same width basis.
Which standards help measure fabric width?
ISO 22198:2006 specifies measurement of fabric width and length in a tension-free, relaxed state. ISO records this edition as current following its 2023 review. Its scope does not cover coated fabrics and it does not assess construction defects.
ASTM D3774-18(2024) covers measurement of woven or knitted fabric width and usable width on full rolls or bolts and on short specimens. Unless otherwise specified, the method includes selvedges when present. If the buyer needs a width excluding selvedges, that requirement must be stated clearly.
Neither standard automatically determines the width a garment marker can use. The buyer and supplier must agree the usable-width definition, exclusions, finishing stage, sampling plan and acceptance limit. Use the method named in the purchase specification rather than assuming that two different reports are comparable.
Worked example: from total width to cuttable width
Illustrative calculation only: suppose a relaxed fabric measures 60.0 inches edge to edge. The buyer excludes 0.50 inch of selvedge on each side and a further 0.25 inch of damaged edge on each side. The available width is:
60.0 − (2 × 0.50) − (2 × 0.25) = 58.5 inches.
This equals 148.59 cm using 1 inch = 2.54 cm. The example is not a standard tolerance or a product specification; the actual exclusions must be agreed and measured on the fabric supplied.
What to write in a fabric RFQ
For example, a buyer could write: “Minimum cuttable width: 58.0 inches (147.32 cm), measured after the named finishing process on relaxed fabric; exclude both selvedges and any unusable edge zones defined in the approved specification. Report total width and cuttable width separately. State the measurement method and agreed roll-sampling plan.” Add a separate tolerance only after the buyer and supplier agree it. Do not leave the supplier to decide what “58-inch fabric” means.
For roll-by-roll checks, see our guide to fabric width variation and usable-width inspection. For fabric sourcing, send your construction, target width, GSM, quantity and destination through our contact page.



