A woven fabric starts with two sets of yarn: warp running along the length and weft crossing from side to side. The loom brings them together, but the work that determines consistency begins earlier—with yarn preparation—and continues through construction checks and inspection. Buyers who understand these stages can ask more useful questions when reviewing a mill’s process or approving a sample.
1. Yarn preparation before weaving
Warp yarns must be arranged in the required order and prepared to withstand the stresses of weaving. Depending on the yarn and construction, preparation may include winding, warping and sizing. Sizing applies a suitable protective coating to help reduce warp-yarn breaks during weaving. Process settings should match the yarn and the requirements of the finished fabric.

2. Weaving: interlacing warp and weft
On a loom, warp yarns run lengthwise while weft yarns are inserted across the width. Their interlacing forms the fabric structure. Plain weave, twill and satin are common structures, each with a different appearance and performance profile. Loom technology, yarn characteristics, machine settings and production control all influence efficiency and fabric consistency.
Air-jet looms insert weft using a controlled air stream; other loom types use different insertion systems. The right choice depends on construction, yarn, width, quality target and production plan. Buyers should approve the actual sample and specification rather than assume that a particular loom type guarantees a quality level.

3. Construction control: yarn count, ends and picks
Fabric construction is described using yarn count and the number of warp and weft threads in a defined measurement. Warp density is often expressed as ends per inch (EPI), while weft density is expressed as picks per inch (PPI). The measurement basis and notation should be clear in the purchase specification. Changes in yarn count or density can affect weight, cover, strength, handle and appearance.
Read our guides to warp and weft density and yarn count conversion for more detail.
4. Greige fabric inspection
Fabric directly from weaving is commonly called greige fabric. It should be checked for construction, width, visible defects and roll identification. Typical defects include missing or broken yarns, holes, reed marks, starting marks, weft bars and oil stains. Inspection findings should be recorded by roll and production lot so affected material can be traced before the next process.
See our practical article on woven fabric inspection before bulk production and our guide to snags, broken yarns and holes.
5. Dyeing and finishing after weaving
After greige inspection, fabric may proceed to dyeing, printing or other finishing processes according to the buyer’s requirements. These processes can change shade, width, weight, hand feel, shrinkage and performance. Hubei Jintian’s spinning and weaving operations are supported by approved third-party dyeing and finishing partners. Finished fabric should be approved against the agreed specification and relevant test results.
6. What fabric buyers should confirm
- Fibre composition and yarn count, including the count system.
- Weave type and warp/weft construction.
- Finished width and usable or cuttable width.
- Target GSM and agreed tolerance.
- Colour, finishing requirements and approved reference sample.
- Required tests, methods and acceptance limits.
- Roll length, roll identification, packing and inspection records.
For TC or CVC shirt fabric, an RFQ should state more than the blend name. Include construction, width, GSM, colour, finish, test requirements and quantity so the mill can assess feasibility and quote accurately.
Discuss your woven-fabric requirements
Hubei Jintian Textile works with woven-fabric categories including TC, CVC, cotton, polyester, TR, twill, Oxford, satin, cotton-elastane and pocketing fabrics. Send your composition, construction, GSM, width, colour, quantity and destination to discuss a suitable specification and quotation. Request current fabric pricing.



