Panty making step 7: bartack the leg and waist openings

Panty Making Step 7: Bartack at the Leg and Waist

This tutorial covers bartack reinforcement, Step 7 in the panty-making sequence. Bartacks secure areas that may be exposed to repeated pulling, but the correct location, length and stitch density depend on the garment style. Follow the approved sample and operation bulletin rather than applying one setting to every design.

Step-by-step method

  1. Confirm the approved bartack locations and number of reinforcement points for the style.
  2. Position the garment securely under the machine without stretching or folding the finished area.
  3. Sew the specified bartack length and stitch density at each required point.
  4. Keep each bartack centred on the designated seam or stress point.
  5. Remove loose threads and inspect the reinforcement without pulling or damaging the surrounding fabric.

Quality checkpoints

  • Bartacks are placed only at approved locations.
  • Stitching is dense, secure and consistent with the approved sample.
  • No broken threads, needle damage, holes, puckering or excessive thread build-up.
  • Leg elastic and waist elastic remain intact and functional.

The operation title references 5 cm × 3. Confirm bartack length and quantity against the actual style specification rather than applying one measurement to every panty design.

This content is blocked because it would connect to YouTube.

Previous step

Before bartacking, review Step 6: join the second side seam and trim threads.

Final inspection

Check the complete garment for seam security, balanced leg openings, even waist elastic, correct label position, clean thread trimming and measurements against the approved sample. Then follow the factory’s final inspection and packing procedure.

Scroll to Top
Verified by MonsterInsights