Fabric dimensional change can affect garment measurements, fit, cutting efficiency and finished-product consistency. Before bulk cutting, buyers should agree on the expected wash process, test method and acceptance limits rather than relying on a general promise that fabric is “pre-shrunk.”
Why shrinkage happens
Yarn and fabric structures can relax when exposed to moisture, heat, mechanical action or finishing processes. Fiber composition, yarn construction, weave, finishing and the garment’s intended care method all influence dimensional change. Results can differ between fabrics even when the composition is similar.
Test the fabric under the expected conditions
Use the test method and wash/dry conditions specified by the buyer or product standard. Record dimensional change in both length and width. If garments will undergo industrial laundering, enzyme washing or another special process, discuss whether additional testing is required to represent production conditions.
Agree the acceptance limits in writing
State the permitted percentage change and the method used to calculate it. Identify whether results are required for every color, each production lot or a defined sample plan. Avoid comparing reports produced under different methods or conditioning procedures.
Consider the complete garment process
Fabric testing is only one part of risk control. Pattern allowances, marker planning, cutting relaxation, sewing construction and garment washing can also affect final dimensions. When a fabric is used in a new style or process, consider a trial garment before bulk production.
What to include in the RFQ
- Fiber composition, yarn count, construction and GSM
- Finished width and cuttable width
- Intended garment and care/wash process
- Required dimensional-change method and limit
- Sampling frequency and report format
- Color, lot traceability and bulk approval requirements
Hubei Jintian Textile can review woven fabric inquiries with the required specifications and performance criteria. Submit your target construction, GSM, width, quantity, color and destination through Request Current Price to discuss the appropriate quotation and testing requirements.
Pre-cutting approval sequence
- Identify the finished fabric lot, color and roll numbers that will be used for the order.
- Agree the test procedure, wash and drying conditions, specimen preparation, number of specimens and acceptance limits before testing.
- Take representative samples from the approved lot and record roll and sample references.
- Compare lengthwise and widthwise change with the order requirement, then retain the report and a sealed reference swatch.
- If a result is outside the agreed limit, hold cutting from the affected lot while the buyer and supplier review the result and disposition.
Use the buyer’s required method where one is specified; the sequence above is an order-control checklist, not a replacement test standard. A fabric that passes this pre-cutting check should still be monitored through garment sampling when the style, construction or wash process is new.



