When a fabric lot is reported as 90 GSM, the buyer needs to know whether the delivered material is close to that target across the lot—not just in one small sample. GSM (grams per square metre) affects fabric weight, coverage, drape and consumption. Before treating a result as a production defect, check that the sample was conditioned, cut and weighed using the agreed method.
Possible reasons for GSM variation
- Changes in yarn count, yarn density, or fabric construction.
- Finishing, coating, brushing, compacting, or other process differences.
- Moisture content and conditioning differences.
- Sampling too close to an edge or from a non-representative area.
- Different cutting areas or measurement equipment.
How to verify GSM
- Confirm the target GSM and allowed tolerance in the specification.
- Condition the sample as required by the agreed test method.
- Cut representative specimens with a suitable GSM cutter or use a validated alternative method.
- Weigh the specimens with calibrated equipment and calculate the result in g/m².
- Take samples from more than one location when checking a production lot.
Corrective steps
If the result is outside tolerance, verify the test setup and repeat the measurement before making a decision. Then compare the actual construction and finishing records with the approved sample. Any reprocessing or acceptance decision should be agreed with the responsible quality team and buyer.
Buyer checklist
Include target GSM, tolerance, test method, conditioning requirements, sampling plan, and whether the figure applies before or after finishing. Do not compare results from different methods without checking whether they are equivalent.
For fabric development, share composition, construction, target GSM, width, finish, quantity, and delivery destination through our contact page.
Use a sampling plan for GSM checks
Agree the sampling locations, number of specimens, conditioning and calculation method before inspection. Take specimens from representative positions across the usable width and from more than one roll when lot variation is a concern. Record roll number, sample position, measured value, instrument and date. A single result from one edge may not reflect the fabric that will be cut.
Compare the readings with the ordered target and tolerance, and distinguish finished fabric from greige or partially processed material. If results vary, map the variation and discuss whether it is consistent across the lot. Confirm any re-test with the same procedure and a traceable sample. Keep the original and repeat results in the same report rather than replacing a result that falls outside the target.



